Light is flickering or the brightness varies unpredictably.
- Evaluate if any potential EMI producing equipment is in the vicinity (high voltage welding equipment, etc.).
- Do not route output power to the light in the same wire-chase as the trigger lines if possible. High current pulses can cause noise to couple into the trigger.
- Use shielded trigger cables.
When strobing, the images are dark or inconsistent in brightness.
- Reduce the trigger frequency, shorten the pulsewidth, or reduce the current until the maximum frequency is no longer exceeded.
I can’t get the trigger to work
- Follow the recommended trigger wiring diagrams in the manual. Try checking or un-checking the “differential triggers” option in the S320 software. Contact our Customer Service for assistance.
The software doesn’t allow me to adjust any settings (all grayed–out).
- Verify the light is connected and that the components inside the “C5” connector are all tightened down completely.
- Avoid extending the cable yourself. If you’ve added an extension cable it must be under 2m long, else contact the factory for assistance.
- If you’re not using an AI branded “C5” light, the output needs a SignaTech identifier, so it will not work unless one was provided to you from the factory.
I am getting an error-code which is not listed in the manual.
- Contact our Customer Service for assistance.